Before seeking assistance, review the following problems and solutions.

Check that appears on the software packaging, or that  appears in the Wii Shop Channel for the title. If neither is present, the software is not compatible with Wii MotionPlus, and enhanced Wii MotionPlus controls cannot be used.

* Is the connector plug of the Wii MotionPlus fully and correctly inserted?
Fully insert the connector plug into the Wii Remote's external extension connector, and slide the LOCK switch in the direction of the arrow until it locks.

* Are the batteries correctly inserted into the Wii Remote?
Insert the batteries correctly into the Wii Remote.

* Are the Wii Remote batteries running low on power?
Press the HOME Button to check the power level of the Wii Remote batteries, and replace them if necessary.

* Is the Wii Remote that you are using synchronised with the Wii console?
Synchronise the Wii Remote that you are using with the Wii console.

If, after checking the points above, there is still no response to your movements, disconnect and reinsert the connector plug of the Wii MotionPlus several times, check that it is correctly inserted, and try again.

The cursor's movement could become unstable in the following cases:

• If the Wii Remote's batteries have been replaced whilst playing a game.
• If the Wii MotionPlus accessory has been disconnected and reconnected whilst playing a game.
• If the temperature (room temperature) has changed. For example, if the Wii Remote was carried from a cold room into a warm room.

If this problem is observed during play, perform the Wii MotionPlus corrective procedure by placing the Wii Remote (with Wii MotionPlus connected) face down on a flat surface, such as a table, and waiting for a few seconds before resuming play.

Depending on your TV, the signal sent to the TV could be displayed only after the image has been processed inside the TV. As this processing time can cause a delay, it is not a failure of the Wii console, Wii Remote, Wii MotionPlus or your TV.

To avoid connection problems with the Wii Remote's external extension connector, the Wii MotionPlus's connector plug is designed to move forward, backwards, left and right. This is not a failure of your hardware, and Wii MotionPlus can be used normally.

If the Wii MotionPlus Jacket becomes detached from the sensor unit, follow the directions below to reattach it.

1. Hold the Wii MotionPlus Jacket and sensor unit facing towards you, as shown in the diagram.

2. Insert the sensor unit into the jacket.
Push the sensor unit into the base of the jacket.
Do not exert too much pressure on areas such as the connector plug.

3. Push the prongs on the inside of the jacket into the holes on the back of the sensor unit.
Stretch the jacket in order to fit the two prongs on the inside of the jacket into the holes in the Wii MotionPlus sensor unit.

4. Use your fingertips to ensure that the jacket hooks at the base of the sensor unit pass cleanly through the two holes in the jacket.
Adjust the base of the jacket with your fingertips until the two jacket hooks are completely visible through the holes in the jacket.

5. Check that the sensor unit is properly attached to the jacket.
In cases such as the ones depicted below, please review steps 1-4 once more and correctly attach the jacket to the sensor unit.

If Wii MotionPlus fails to operate normally even after performing the steps above, please contact Nintendo Consumer Service.